Assign a MEP/MIP Level to an SPBM B-VLAN

Use this procedure to assign a nodal MEP to an SPBM B-VLAN. The Nodal MEP provides traceability and troubleshooting at the system level for a given B-VLAN. The Nodal B-VLAN MEPs created on the CP and function as if they are connected to the virtual interface of the given B-VLAN. Because of this they are supported for both port and MLT based B-VLANs.

Nodal MPs provide both MEP and MIP functionality for SPBM deployments. Nodal MPs are associated with a B-VLAN and are VLAN encapsulated packets. Each node (chassis) has a given MAC address and communicates with other nodes. The SPBM instance MAC address is used as the MAC address of the Nodal MP.

Before you begin

  • You must configure a CFM MD, MA, and MEP.

Procedure

  1. Add nodal MEPs to the B-VLAN:

    vlan nodal-mep <1-4059> WORD<0–22> WORD<0–22> <1–8191>

  2. Display the nodal MEP configuration:

    show vlan nodal-mep <1-4059>

  3. Remove the nodal MEPs from the B-VLAN:

    no vlan nodal-mep <1-4059> WORD<0–22> WORD<0–22> <1–8191>

  4. Add nodal MIP level to the B-VLAN:

    vlan nodal-mip-level <1-4059> WORD<0–15>

  5. Display the nodal MIP level configuration:

    show vlan nodal-mip-level [<1-4059>]

  6. Remove the nodal MIP level from the B-VLAN:

    no vlan nodal-mip-level <1-4059> WORD<0–15>

Example

Switch:1> enable

Switch:1# configure terminal

Switch:1(config)# vlan nodal-mep 100 md1 ma1 2

Switch:1(config)# show vlan nodal-mep

================================================================================
                                 Vlan Nodal Mep
================================================================================
VLAN_ID    DOMAIN_NAME.ASSOCIATION_NAME.MEP_ID
--------------------------------------------------------------------------------
100       spbm.100.6
200       spbm.200.6

Switch:1(config)# vlan nodal-mip 100 6

Switch:1(config)# show vlan nodal-mip

================================================================================
                              Vlan Nodal Mip Level
================================================================================
VLAN_ID    NODAL_MIP_LEVEL_LIST
--------------------------------------------------------------------------------
1
100		    6
216
304
41000      
1001       

Variable Definitions

The following table defines parameters for the vlan nodal-mep command.

Variable

Value

<1-4059>

Specifies the VLAN ID.

WORD<0–22>

The first parameter, specifies the Maintenance Domain name.

WORD<0–22>

The second parameter, specifies the Maintenance Association name.

<1–8191>

Specifies the nodal MEPs to add to the VLAN.

The following table defines parameters for the vlan nodal-mip-level command.

Variable

Value

<1-4059>

Adds the nodal MIP level. Specifies the VLAN ID.

WORD<0–15>

Adds the nodal MIP level, which has up to eight levels, ranging from 0 to 7.